Reconyx Hyperfire Manual de instrucciones descargar pdf (Pagina 19)

www.reconyx.com 18

Mounting Your Camera

Your RECONYX™ HyperFire™ camera can be mounted to a RECONYX™

VersaMount™, ThunderBolt™, or camera tripod by utilizing the threaded insert

on the back of the camera housing.

The camera may also be mounted to a tree by using the included adjustable

bungee cord (shown below). Simply thread the end without the loop through the

“Lock Tunnel” on the camera and then install the included adjustable bungee

hook to the length needed and fasten to the tree.

Mounting Camera with Adjustable Bungee Cord (included)

We recommend that you mount your camera about chest height and angle it

slightly downward (using a camera mount or stick if needed). This is optimal for

detecting animals in the field of view of the camera as well as for accessing the

camera’s card, batteries, and controls.

NOTE: It is highly recommended that you use a theft deterrent device such as a

security box and/or a Master Python Lock™ to help secure your camera

against possible theft when it is in the field.

You can purchase HyperFire™ compatible mounts, theft deterrent cables, locks

and security enclosures at www.reconyx.com

TIP: If you are concerned about the slight red glow of the illuminator on the lo-

glow camera models (HC500 or PC800) spooking animals, you can mount

the camera a bit higher and angle it down. Most animals do not often look up

and therefore are less likely to notice the camera if it’s mounted above eye

level.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Sin comentarios

Reconyx Hyperfire Manual de instrucciones Pagina 19